[redline_or_nothing]

Thanks for the help everyone and I did model a different hood to begin with. I used the toms castrol supra blueprints and made the hood as close to it as I could. I just like the plain hood best so i did most of my renders with it. Here are a couple of pics of the vented hood:


I have tried to get the reflection that starts after the door to match up but I have the polys going at too extreme of an angle that it will not match up unless I move the vertices back to align with the door edge, and that makes it hard to keep it widebody. I have decided to just start new with stock supra blueprints and I have done the hood to begin with and was hoping you all could coach me through it. This will be my fourth time trying to get this car decent and smooth. Here are some pictures of what I have so far:



Ok, if the hood is good enough, where would be best to start doing next? In the past I have just cloned all of the front edges forward and started shaping the headlight lens and front bumper, but I cant remember exactly how I did it but I know I had a time just getting the headlight lens started right. I have a printscreen of the top view and could you tell me how to aproach the headlight lens the best way. Thanks again for your help. Here is the pic of the top view: