Image won't 'refresh' in ZModeler

[DarkVenom666]

Hi,

I've cut out and prepared all the needed images to start modeling a car. Though, as i was loading them in ZModeler, i realised i made a mistake; 1 image needed a 90-degrees rotation in order to fit in. So, i did the rotation, saved it and re-opened it, but the old image appeared. It did the same after a restart of ZModeler and the same after a reboot of the computer. I've also deleted the textures path of the needed files and put it in again after the reboot, but the old image stays.

Can anyone tell me how to get my new image into ZModeler!?

I apologize for this rather dumb question, but the image just won't get in!

Dave.

[mohus]

try to rename the new image then go to the view right click/backround/image/load and select the old one and hit replace texture it worked once for me (zmodeler 1.07b)

[DarkVenom666]

Thank you for your support, but whatever i do with the file, the changes aren't picked up by ZModeler :? .

Maybe re-installing it would help? Oh well, i'll save that for tomorrow, i'm fed up with my computer for the day :wink: !

Thanks again,

Dave.

[superwes88]

if you remove the image from zmodeler, save, exit, check if you dont have top.tga and top.bmp or something like that, run zmodeler, check if it's good now, I'm sure you'll be fine. It's truly impossible that zmodeler rotates the image 90' itself