how to join vertices

[picadilly]

hey i was wondering if any 1 could help me to understand how to join the vertices from the front view with the side view. if u dont quite understand what i mean. After u hav made the poly for the side view the vertices on the front view dont line in the right place with the side view.

So i would like to know how to move them without the polys that i made for the side view

[Johnas]

It would help if you mention what program you use. And maybe a pic would help

[picadilly]

well am useing Zm1.v107 program but in respect to the pic i will hav to send that to u later cause i don't hav it here with me
Ps thnx for the responce

[Johnas]

Well hopefully this helps a bit. You have to move the vertices next to each other before you can weld them. Or is it unify in zmod?

[NightEye]

Select, press u.

[picadilly]

hey in respect to my problem that i was facing with the vertices, i sent a pic that u can see apart from tbat i made a a small statement that may help understand my prolem
* * * *Ps: much thnx for the help

[NightEye]

Select;
Modify../Move;
SEL on;
X-axis;
Click and drag;
Deselect;
Done

[picadilly]

thnx for the reply in addition to that i would like to know what to do next in term of modification to the side & the rest of the car plaz
* * Ps: any advice would be greatly appreciated thnx again*

[NightEye]

Just make is as accurate and nice as you want, then start with the smoothinggroups (detaching), and perhaps some texturing