|
|
 |
 |
 |
|
|||||||
| General Discussion General Discussion |
| |
 |
|
|
LinkBack | Thread Tools | Display Modes |
02-12-2004
|
||||
|
||||
|
Need help with LW print setup...
I have a problem with the print setup in LW...
1) the topview isn't scaled right... The print itself is... So LW just doesn't show every view at 100% of its scale... 2) The topprint is rotated wrong... It should be faced downwards, but nomather what I try (even editing the print), it keeps facing to the right...  Any help is appreciated    If you can't stand the heat, don't walk into the fire... 
|
|
02-12-2004
|
||||
|
||||
|
Need help with LW print setup...
Aiight yo, this is what you do.
Make sure the top print is cut out and facing down. I usually have the top pic on the top left. To make sure it's line up correctly, you put one point on each end of the side prints. Then go to the top viewport, then click "a" and it will line it up, so you see the both points.. Then change the size in of it, so the prints are as big as the prints.. I hope that helps.. If not, I can make you a video.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Confirm Good Print | XSImatrix | Requests | 2 | 07-13-2005 08:13 AM |
| how to setup a motorcycle blueprint???? | funklee | General Discussion | 5 | 04-08-2005 04:39 PM |
| request: maya texturing tutorial - usefull car paint setup | TitanMika | Requests | 0 | 06-16-2004 06:52 PM |
| help with blueprint setup | dreamreality | Tutorials | 6 | 05-18-2004 08:44 AM |
| print does'nt work | s2k | Corrections | 2 | 01-29-2003 08:34 AM |
|
All times are GMT -5. The time now is 02:43 AM. |
Linear Mode
