[Good old 80's] 1989 Lancia Delta HF Integrale 16v

[wild_coyote]

I've been modeling for about 4hrs and this is what I've got so far. Just trying to get the overall shape. At the end it will probably have about 500.000 polys

[wild_coyote]

I've worked couple of hours yesterday and few today. Had some problems with rear door but now it's ok. Now I'm working on the hood.

[multimediaman]

looks like the trim at the bottom is out too far where it meets the front wheel arch... but then again I'm not familiar with this car, so that critique doesn't mean much

[wild_coyote]

I've worked a lot and didn't have time to post 'till now. Here's what I have so far. Should finish modeling in 2 or 3 days. The hardest was rear quarter panel. It covers area below windshield, A & C pillars, roof and rear quarter panel. I still need to model fuel cap on the left side.
Side mirrors, trunk door and rear lights should be finished tomorrow. Probably the hardest part I still need to model are rims. They're pretty tricky (you'll see when I make them ).
So far I have about 130.000 polys for one half of the car.

@multimediaman - you're right! I've tweaked it and now it looks good.

[tom120934]

Your work looks really great. My only concern is about the doors handles : they looks a bit undetailed on your renders. Can you post a closer view ?

I would appreciate to see the whole car on your pictures, and not a single half. It will allow everyone to seek more efficiently for issues, if any.

Keep us updated, it's an excellent work on a legendary car !

[mihai_cpp]

As tom said, it would be nice to post the full car not only one half of it, the work as i see it is excellent, nothing bad too say about it.

[wild_coyote]

Small update.
I've finished trunk door and some of the rear light. Since deadline is soon looks like I'll have to push harder.

[multimediaman]

looks like you're progressing quite nicely. no critiques, just wanted to offer some moral support

[wild_coyote]

I finally finished modeling. Maybe I'll need to tweak some things around tail lights, but I'll leave that for tomorrow. My poly count is just a bit higher than I thought (360.000 higher!!!).
I still have to make textures and setup lights and render but I'll leave that for tomorow. I'm gon'na rest now 'cos I caught a cold and everything looks a bit blurry!

@multimediaman: thanx for support

[tom120934]

The modeling job is really nice. I have no critics about it.

You should try to produce a clay render with a floor plan and a skydome above the car. The lighting is not good as the modeling, it doesn't do justice to your work.