Lancer EVO6

[Beastatron]

Hey everybody this is a car I'm making for a project in school. It's supposed to be a Lancer Evo 6 but I'm not going for super accurate. I'm using 3ds max 3.1 ( ) so it's a bit harder to model. (No editable poly mode!!) Anyways tell me what you think and what I could do to make it better. Thanks.

[CobraX]

Looks smooth, but that is defiantely not Lancer Evo 8. Something between 1 to 6, but neither 7 nor 8.

[Beastatron]

Yeah I dont know if the prints are even an Evo 8 but it said they were. Anyways heres a tiny bit more work. :roll:

[Beastatron]

Ok it's definately an Evo 6. Sorry for being so foolish. It's the weekend so I won't have any more work until Monday. BTW, this is my first car. Please point out errors/uglies. Thanks.

[CobraX]

Already said, that it looks good, but there sseems to be a minor mistake in the area where the edge through the hood meets the headlight howle. Looks a bit strange, but this won't be a problem for you.

May you show us a wire?

[Beastatron]

Yeah I noticed that but didnt have enough time to fix it. (Bell was about to ring.) I'll post a wire on Monday and some more work. Thanks for showing interest.

[rianshima]

my firend went to japan and got some pics of a evo 6 i think it was. here check em out mabye thy could help

[Worlds only hope]

It says Its an Evo V (5) on the bumper :wink:

[Beastatron]

Thanks for those pics. I was supposed to have more work yesterday but the stupid program at school crashed and I lost my file. I started over and have some work done which I will post tomorrow. (Hopefully :roll:

[Beastatron]

Alright heres some more work. Had to completely start over. There are some smoothing errors where I need to get rid of some triangles but I'll do it later.