[SCION] Need Some Help with the edges, corners, intersection

[kennfletch]

i know its wrong but I just didn't want it to smoth out with the meshsmooth. go easy on me I'm a newbie

[wdcstudios]

try welding all that back together and chamfering the edge by a small amout that will keep it from smoothing

[doch_1]

I didn't understood what help you needed .
it's look like poly modeling .
maybe if you show all the picture and point up
the problem more specific . and not so... close up .
it will help us to help you .

[kennfletch]

well thats the area i want help with right now. Why show the rear is all i want it this section????

this is the area I want to work on exactly what is pictured

[skb875]

Sweet a Scion :] Is it the tC?
About that part, get rid of the 3 point polys, and make them 4 point polys.. It should look like it's wrapped around that. If you don't understand what I'm saying I can make a pic.

[kennfletch]

yea thats what I want a pic thanks very much and yes, thank the gods its tC.please. I know peopel wanted this bad, lol

[kennfletch]

what i have so far. I'm going to depend on you guys for this one, be nice, lol

[skb875]

Hey, there's probably a better way of doing this, but this is what I'd try.. Might leave a bad mark on the bumper, but play with it.

[teon_l]

ive been doing 3d for maybe 6 mnths and i want to do a car.. a scion tC definately. where dod you get the blueprints?

[kennfletch]

What Blueprints? lol, thats funny,

I can't give you something I don't have. Let me know if you find them. tC that is. I'm wingin it

[HardKnox]

heres a few i found with a link to more ref

[kennfletch]

like i said let me know when the blueprints come out

[celica1985]

you have too many polygons in areas

notice the red outlines in 3. you can get away with that and still get the desired effect. also reduce along the rest of the top and front to compensate.

in 1 it looks like you have way too many edgelines in there. you only need 1 camfer to get a proper edge in meshsmooth. if you put too many too close to gether it will not work right.

the red edgeline in 2 is not needed (i dont think) remove it if its really not needed

as a rule of thumb use only 4 sided polygons and dont have 5 faces connected at a edgeline. 3 siders can work in certain situations but 9 times out of 10 they will just distroy your meshsmooth.

[celica1985]

these might help your other question as well