BMW E36 Cabrio

[KreuZer]

Hi again
Now i know the basic techniques of MeshSmoothing i started a new project: BMW E36 Cabrio
Flat+Wire
Clay pic..
Smooth :roll: (hard edge in the middle will be smotthed out)

C&C welcome and required

[andybuck]

not a bad start, some things need sorting. Since im modeling this car also i kinda know the car from every angle from alllllll those ref pics lol, the line traveling down the side of the car isnt there? you probs know this one, the hood isnt cut out yet. make it a bit smoother and sharper in places. Maybe take a look can compare my model with yours, see how i did bits and stuff. Might help a bit ill keep an eye on this one

[DrumBoPing]

does look good .. take andy's advice

[steveee]

mm, its ok, there are some bumps on the bonnet, nd some of the lines are not sharp enough on the bonnet.
Take a look at andys, now thts some good sh*t

[KreuZer]

Some Updates.....
C&C required

Looks really nice
Could you add a symmetry modifier?

[mpfive]

looks really nice

[andybuck]

I think you should do the fixes i suggest in the image below