Lancer Evolution VIII First Model

[beanshitman]

Here is a my work so far. Any help would be good. I know everyone else does this car but I love it.

Front

[beanshitman]

This is what ive done so far. Redid the first one. Here is the max file. Please give me some suggestions.

[clix101]

quite good for a first model bean****man but you should try to start small ( eg an easy car ) and get bigger ( eg work up to a lancer evo VIII lol )

but dont stop! keep going, i want to see more

[Themainkiro]

The evo is a very hard car to mode I still don't dare to model it ( I am afraid of it :roll: ), the best beginners car is probabli the audi TT, but since you have started you can finishe it and after some time when you think you have aproved you can remodel it again and you can compare the two cars and so you'll see how you have aprooved yourself, for example I have remodeled the BMW E36 3 times and I am still not satisfied with it and probably I'll remodel it again, so GOOD LUCK

[beanshitman]

The front bumper is the hard part. any suggestions on to start a plane in front top or side

[beanshitman]

another try, I looked at some tutorials got better I think.

[beanshitman]

Look

[beanshitman]

I tried many diferent things with the front but cant figure it out.

[polarexpress17]

well for starters you could line up your fender w/ the side of the bumper

[Flexdude]

reasonable start dude. I dont blame you for wanting to do this car, its one of my favorites too. I agree with others, its a hard car to model, I didnt attempt it til after about 6 months of practice. Im not saying my ones perfect, because its well from it :roll: but heres my wire if its any help for you mate.

[beanshitman]

thx

[beanshitman]

Here is my max file lots of work done. Still not even close to being done. Someone plz look at it a give feedback if you can.

[beanshitman]

Wire frame of back....getting better at max
[img]http://members.cox.net/bean****man/wire.jpg[/img]

[skb875]

Might wanna post a bright picture of the wireframe. That's kinda hard to see. Also, it's easier to crit on a wireframe when you have a gray material on the car and then the wireframe

[beanshitman]

I need to make the lines on the car stand out like where the creases are. any sugestions

[zac_3d]

hey man nice try i am modeling this car at the moment aswell and its a tricky one. the only help i can give you is to slow down and take you time and to make sure that you only model out of quads and only use triangles when you really need it kkep it up dude