Highpoly Nissan 350z

[mikolc]

Looks promissing. Keep it up.

[Silent Screamer]

well another up date... i think the door is a bit wobbly, i'll try and fix it, also what do you think about the seam, open them up a bit?? also about the meterials they suck, i'm to lazy to put my good ones on it for now... thanks so far for the comments!

[DJP]

i think it looks much better. yeah i think the seams should be open a bit. just very little

[mikolc]

Very nice work so far.

[Silent Screamer]

here is a bit more, i tried not to use the tutorial for the rear bumper so that i can make sure i know what to do with constantly referancing something.. let me know what you think.

[Xer0123]

You're getting much better so fast. But the front bumper reflector/light thingy is out of shape and the rear bumper's light thingy is too round.

[99GsTurbo]

ur seems are looking better. I notice u don't use a custom toolbar because in ever pic, u have the primitives toolbar up. u should really build ur own custom 1 as u work. everytime u use a tool that u notice ull use a lot add it because it can save u hours on ya work. keep up the work

[Silent Screamer]

I was wondering if this was the best setup for the front blinker, because on the tutorial he just extrudes the edge inward. thanks ahead of time.

[skb875]

Here, this might help you out a bit.. It's a wire of my 350Z.. It's not here to show off, just tryin to help. I can remove the link at any time if you wish.
http://img54.imageshack.us/img54/1187/wire1ll3.jpg

[Silent Screamer]

how does it look now, i find its relatively close to the pic i have from diesel station( they have a really nice front end shot, but at a wierd angle)

[Xer0123]

it looks really wide, but if you think it's correct then keep going cause the mesh looks nice otherwise.

[Silent Screamer]

here is a bit more on the back end, i hope i fixed most of it up, going really slow now, i'm not using the tutorial at all to try and see if i can really do it on my own, i think it looks fair, let me know what you think.

[Silent Screamer]

well i started over because the seams wheren't linning up very good, so i'm makin it a whole now and then going to split and make the seems later, so here is abour 45 min work so far.