RX-7 Fortune - SMCars

DragonArt · #1 (**permalink**) 02-17-2007

I'm back. I have traind my modelling skills and I have taken up the old challenge - the Mazda RX-7 Fortune. Now it's almost compeletely remodelled and I hope it's better this time. C&C welcome.

***mpfive*** · #2 (**permalink**) 02-17-2007

its too narrow man, make it wider, try to even out the spaces between where its possible as much as possible

jsruk · #3 (**permalink**) 02-17-2007

you are using my prints right? mpfive is right, have to be wider

DragonArt · #4 (**permalink**) 02-17-2007

Thanks, dudes, I'll make it wider when I get back home. Any suggestions on wire?

jsruk · #5 (**permalink**) 02-17-2007

wire looks good

feral1 · #6 (**permalink**) 02-17-2007

coming along good , but has to be wider as stated earlier.

DragonArt · #7 (**permalink**) 02-18-2007

Thanks, I made it wider and fixed some minor pinches.

***mpfive*** · #8 (**permalink**) 02-18-2007

EY, this is a wide body kit on teh car... dont be afraid, make it WIDE man, it looks like you are making it wider by small increments, just make it wide, and we'll tell you if it looks fine or needs adjusting

DragonArt · #9 (**permalink**) 02-18-2007

All right, now it's even wider. I'm just afraid of making it too wide

Does this look any better?

PiktasDede · #10 (**permalink**) 02-18-2007

now it looks much better!!

keep working on it... Good job

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)