Mitsubishi Lancer Evo IV

[crazyradek]

This is my unfinished Evo that i'm start one day ago



I must delete front and do it once again

[Catlin]

what prints are you using for that looks good so far i wanted to make a makkinan edition.

[crazyradek]

I've used this prints http://www.smcars.net/forums/mitsubi...lution-iv.html

[crazyradek]

A little update


the right side of car is detached and the left isn't ;]

[feral1]

looking good, just need to close the bumper up, or at least zero the polies.


keep up the good work

[LOST]

It is lookin' better that before. Good luck!

[rallydriver]

It seems to have some bumps all around the model. Can you show as a solid wire and a clay render?

[crazyradek]

later i post some studio renders I know the wire is suck, but i going to finish this car

[PunkGuy]

hmm.. not so clean! and alot of polys.. tomany for the result youve got.. alot of useless olys also..

[LOST]

After look on your wires I think that you should delete tires and make new one with no more than 2-3 wide segments.

I think also that rims should be more detailed.

Finally I think that rear spoiler should be also more detailed (should have more segments).

[feral1]

you are getting there, but I think you do need to get rid of a lot of polies.
the front fender is deformed due to polies amount and placement.
you have cuts in headlights and indicators on an angle that do not need to be there. the door handle area has a lot of cuts all the way to the bottom of the door and skirt area, remove as many as you can. I would say 1 each side the rest to go.
I hope this helps, including what other have said.
We all have gone thru this and some of us still are.

good luck keep it up

have a look at image to see what I mean, the green areas remove the angle polies.

pink remove each of the lines where there are 2 close together make it 1

yellow make line straight across.

[crazyradek]

Thanks I will do this I'm going to make OZ Racing Wheels

[crazyradek]

Wire:

and studio Render:

and Clay


I know there are some bugs visible on the Studio render but i repair them.

It's small update because i don't have much time to finish this project ... but more update will be soon

[LOST]

Lookin' better, but I think that you still have too many edges near of the door handle.

[crazyradek]

these polys is for ditches and that is why there are many edges (sorry my bad english)

[Stachu]

wire is too dense and missing chamfers.

why you don't show this model on pchteam??

[4yBaK]

if I'm right u use mirror.. forget the mirror plugin man use Symmetry its much better and u got some bumps man like on the rear doorhandle, front bumper have a good look @ poly row that going from the grill down to the bumper

[crazyradek]

i don't show this model on pchteam cause mk2 will be angry and i show it there when i finish it

[crazyradek]

An update

[Stachu]

omg flying car! ugly studio ;p