BRABUS S V12 S Biturbo

[P.Y.R.O]

Ok guys another car, I have planned this because i really wanted to do a merc , i started Sl500 but then i dropped it, and started this 65.
I plan to do the brabus body kit. No idea is i change later.

Here is the progress that i have made so far.
Renders and wires
Critics are welkome.
I would like top bring to your notice that the fender has go few slight bumps that might not be visible, but i will rectify with a new post.

Plans - i have planned to do this car as accurate as i can ,car will be highly detailed to the best of me, i have learnt a lot from the evo i did and i plan to do its engine also , project will take long time, i will be doing it slowly as i am practicing organic stuff too.

[P.Y.R.O]

Wires

[P.Y.R.O]

Well this thread has resurrected here are some updates
1. Made door lines
2. Made front grill
3. Some progress on the bumper

Pics:-

[LOST]

It looks very good so far. I can;t wait to see it finished.

[300zx_9]

that looks really smooth and clean, i think this one would be a good one just like your evo, but one question do you start modeling with the hood?

[clix101]

looks really nice and smooth, but dont forget the hood/bumper line

[P.Y.R.O]

Lost - happy you liked it..!

300zx_9 - Yes , i start off with the hood and then the bumper and then fender side by side and then the room adn then back windshield and then the doors by extruding from fender and then the rear fender. and trunk hope that helps.

clix101 - i wont forget man ,