Ford S-MAX

[jms_3d]

hey started a new car the otherday. A Ford S-max

havnt finished the front bumper yet and i know there is a few inaccuracies with the model but i think it looks pretty good so far not bad for my first model without a top blueprint...

c&c welcome

BTW i will post a wire pic soon

[ibeam]

looks like a nice start. could you post some wires though because there are a couple spots on the front bumper that maybe a bit off.

ibeam

[jms_3d]

Here they are

[Erik_S]

it is lookign really nice. I like the choice of the car, yo udon't see them very often modelled. The start you make is good, only some crits depending on the wire and 1 bump.

Picture: red place is a bit bumpy
Wire: the red lines are an added row of edges, the blue lines are those edges deleted!

Hope you can use it, and keep it going!

[ibeam]

erik stole my thunder and pointed out most of what is bothering me. the only thing that i would add is that i think the crease going through the circular trim for the foglights (i presume that's what they are) should probably fade out a bit at the end so that it looks more circular.

ibeam

[jms_3d]

@ Erik_S : thankyou I will do this next time i open up 3ds max

@ ibeam: thanks that crease is suppose to be there...for some reason :roll: REFRENCE pic

Thanks for the comments and help , i will get those bits sorted out

[ibeam]

i see what you mean in the reference pic. my overall point, though, is that the opening ceases to look round because of the way you've modelled the crease. it's a nitpicky point though so don't lose any sleep over it

ibeam

[Nero]

really nice and clean i wanted to make this car too

[jms_3d]

thanks

Heres the rim for the S-max and a tiny bit of progress need to fix a few things for it but i dont think it looks too bad

Merry xmas

[ibeam]

looking smoother. on the far side, i think i see a little bump on the bumper at the top of the hood but other than that you're doing good.

ibeam