Honda Civic-R 2007 (My Blender First Project)

[bobi_chen]

Hi all, finally

This is my first post here and first project with Blender.
This Project is for my own Portfolio, and really need critics and comments on the process.


The Front Bumper still need a lot of tweaks :?
and hopefully I can finish it in a month.

I really love this car.

[tom120934]

You should post bigger pictures next time. Also, use the attachment system.

In terms of surface, the hood looks OK, the same for the fender. The front bumper is good except below the headlight, you have a wavy surface there.

In terms of mesh, you should re-equilibrate the hood : some areas have high density of polys, some doesn't. Getting a more homogeneous mesh will save you some time later if you have to modify the mesh.

Keep us updated, it's a nice start.

[schaefft]

Good choice of car, I like the sedan most.

[bobi_chen]

Hi Again,

Thanks Tom, here is the update(using the attachment now )
I'm quite busy right now :x. but I'll finished this one

C & C please

[tom120934]

You have a bump on the side of the rear license plate. Also, the front bumper doesn't look that smooth, but it's hard to say, maybe it's just an artefact from lighting.

Otherwise it looks good. It's nice to see you're still working on it. Keep us updated !

[advan]

FD2 civic is by far the best looking one. Defintely worth modelling - good job so far

[jms_3d]

Apart from a few bumpos and inacurices this isnt looking too bad. Well done man keep up the good work

James

[bobi_chen]

Thanks for the comment guys,

Tom-- bump on the side of the rear license plate, mmm I thinks its because the polygons density is a bit higher there. I prepare that for the rear light. the rear lights is separated in to 2 part , on the body and the trunks. It'll shown on the next progress. thanks for the comments btw.

I think my memory being confused on the shortcuts. I used 3dsmax and blender daily. So some times the shortcuts becomes swap. :? But its OK, it the process I think.

[tom120934]

OK, I know from experience how complicated it may be to handle correctly mesh density within Blender. Maybe it's difficult as well with others packages