DINGSIGNs Zmodeler Thread

[Icekid84]

I know this is picky.. but how do you get the wheels on if this were a real car? I mean the size of your center leaves no room for a bolt pattern, and even if you were going to go with a racing center bolt it still is too small not to mention not there. Another bad thing about having such deep wheels on the front is it would be harder on the car to turn them.

[Johnas]

I like how the back looks

Also you should make front door wider, so it would go further to the back.

[Nik]

I normaly dont like fantasy cars but this one looks very cool, nice work.

IK: Maybe itis like a F1 car, one bolt.

[viktording]

small update.
Pics made with Deep Exploration

[Icekid84]

Much better Looking good so far

[viktording]

some more pics.

no update though, have to design the interior yet

[viktording]

Here is a quick paint-drawing showing the interior design.
Seats will be the same (or slightly edited) as in the aeon. The same to the steering wheel

[viktording]

Some more pics.

Interior (without seats and steering wheel yet) is done.

4810 Polies. A very nice polycount for NFS4 I think.


Also played around a bit with bump-mapping. (The doorlines are still textured )

[Icekid84]

I actually really like this design, a lot better than what Porsche came up with for their venture into 4 door saloons. Anyhow I believe you said this was going to be low poly for NFS4.. but maybe later you can start chamfering your edges. Its possible but very hard to go back on a finished model and do it without a program with even a cut tool. But that would really make this car and even your other miles better. Youd still have your edge look but it would be more realistic.

[viktording]

So, the interior is nearly done.

The seats are a bit highpoly though....282 polies per seat. Maybe Ill do some cuttings.

Total Polycount: 6210.
Estimated Final Polycount without cuttings: 6,5-7k