Mini Cooper S 2007

[minifong]

Hello everybody!
This is my first thread in this forum!!

Erm.. I thought it was about time I start modelling this beauty.
So, I started modelling this last week while trying to cope with school work..

here's the progress so far..

c&cs are most welcomed! thanks in advance!

[VsQ]

Looks nice, just finalize those seams
Keep it up!

[Prykie]

Looks like a nice start, will look better when ya put the seams on it

[minifong]

thanks VsQ and Prykie for the reply!
was afraid of putting in the seams in case I had some major mistakes in the shape..

looks like its good so far so.. yep i'll be doing the seams later..
thanks again!

[Fl0]

looks nice!

wich blueprints do you use.

[rdelt]

Looks good so far. Thats sort of an odd technique your using IMO.

[Niray]

Clean work, post some wires please

[minifong]

Just added the seams, nothing much.. thanks for the replies

F10: i'm using the one posted by RedStar in this forum.
http://www.smcars.net/forums/mini/22...i-coopers.html

rdelt: thanks!

Niray: thanks a lot! i'll post wires in the next post

[jms_3d]

looking very good do yu think you could post some bigger pics please?

[RedStar]

Not bad your gettin the hang of it now here are a few issues iv noticed.

You have to work on your seams, right now they make the car look cartoony, if thats your aim then good job if not make them sharper and ull give your car a greater look right away!

Next is your back, not sure whats going on but as soon as you got to the back your model is gettin worse. Not sure if your getting board with it or if the back is something that you struggle with but you might want to look into that.

[clix101]

the seams do look a bit too wide apart or smooth, but i think the modeling is pretty good, once everything is complete, it'll look a lot better

[minifong]

jms_3d: thanks, bigger pictures

RedStar: hello! thanks, wouldn't have realised my seams aren't sharp enough, will work on it! and about the back.. erm.. I had some problem with it, it was a little off the blueprints.. trying to fix things now..

clix101: hey! thanks a lot, will definitely sharpen the seams..

but for now, did some wire shots and erm... the back lights and some other stuff.. i'll be doing the headlights, the badge at the side and the side mirror after this..

c&cs welcomed!

[Prykie]

Looks good, try showing us the wires without any smoothing on, we can get a better look at your wire system then.

[tom120934]

Nice work, I agree with Prykie, you should show unsmoothed wires.

I also require some bigger pictures for your clay renders. It will help to see bumps if any.