Dodge Challenger SRT8 in real-time 3D viewer The Gallardo is nearly done but for a special purpose I need another vehicle. It's the Dodge Challenger SRT8. One of the best revived cars at all. This time I want to present the project in real-time. A plugin is required but allows smooth 3d art in your browser then. Click the link below to start the 3d model viewer. Of course there might be problems with very slow computers. Click for interactive 3D model viewer 6MB What you see is the raw body without any details. In many cases I had to reshape the surfaces for a perfect shading again and again and it would make no sense to always redo the details before the body is final. The polycount is not worth a mention since it has a lot of potential to get optimized. It's moving around 40.000 tris for the body and 20.000 tris for the wheels. SSAO is temporarily active and might cost some frames. This is going to be deactivated later. I want to open the hood, the trunk and the doors. For the exterior a low detailed cockpit is intended. A high detailed cockpit comes for the first person view. My next objective is the 6.1l HEMI 425hp engine with openable hood. This car was very tricky because the existing prints are very inaccurate.