Ford Raptor SVT (WIP)

#1
New thread HYPE! :D

So my on and off project since January is the Ford Raptor. Nice car to try some crazy stuff with, mostly to try all sorts of raps for it and have a go modelling all its guts :confused:, also practice UV'ing for some dirty renders way way down the line.

As of now there are a lot of issues all around the car, mostly that front fender region. if anyone can point them put, then it shows I can't ignore it.
Harsh criticism is appreciated... so do your worst, Thanks you :)




SVT_001.jpg SVT_002.jpg SVT_003.jpg SVT_004.jpg SVT_005.jpg SVT_006.jpg SVT_007.jpg
 
#2
nice start to this, about your fender just make sure everything is welded together because sometimes 2 vertex not welded can do this kind of distortion. if it don't solve the problem try deleting the faces and bridge everything back
 
#16
Hey guys!

Significantly big update! I was hoping to finish all the blocked parts before posting but it's turning out to be very hard and time consuming. Trying to figure out scaling of each part is the hardest issue ,especially figuring out the shape of the chassis :(

The chassis and front suspension parts are blocked out until i can be sure of the proportions. The rear is close to complete except for some finishing touches; bolts, screws and a lot of other small pieces, also connecting all of it to the chassis, but that comes later o_O

:)

SVT_023.jpg SVT_024.jpg SVT_025.jpg SVT_026.jpg SVT_027.jpg SVT_028.jpg SVT_029.jpg SVT_030.jpg SVT_031.jpg
 
#17
Hey guys!

Significantly big update! I was hoping to finish all the blocked parts before posting but it's turning out to be very hard and time consuming. Trying to figure out scaling of each part is the hardest issue ,especially figuring out the shape of the chassis :(

The chassis and front suspension parts are blocked out until i can be sure of the proportions. The rear is close to complete except for some finishing touches; bolts, screws and a lot of other small pieces, also connecting all of it to the chassis, but that comes later o_O

:)

View attachment 161871 View attachment 161872 View attachment 161873 View attachment 161874 View attachment 161875 View attachment 161876 View attachment 161877 View attachment 161878 View attachment 161879
Pretty good work on the detail of the rear axle and brakes. Like the chassis.
 
#18
It's been a while so here's an update. Most of the car is done except the interior, which I will work on in the future. The chassis is finished, it just needs all the holes in place and some small changes here and there. I'm still thinking about the engine area, mostly the transmission because that would be the only part visible. It would take some time to work out the proportions with the exhaust.

raptor_04.jpg

SVT_041.jpg SVT_042.jpg SVT_043.jpg SVT_044.jpg SVT_045.jpg SVT_046.jpg SVT_047.jpg SVT_048.jpg SVT_049.jpg SVT_050.jpg SVT_051.jpg SVT_052.jpg
 
#20
Hey all, finally doing some test renders to have a break from modeling...

I've started playing with some mud textures, so expect some messy renders :D

raptor_1.jpg
raptor_2.jpg